Multisystem Bar 3D
Они позволяют производить самые разные формы с 2D и 3D изгибами по часовой стрелке и против часовой стрелки. Они работают с прутками, нарезанными по размеру, диаметром от 10 до 40 мм (#3 - #14).
Multisystem Bar 3D
Automatic Shaping Center 2D and 3D
2D OR 3D LARGE STIRRUPS AND SHAPES FROM CUTTING LENGHT BAR
BARS ∅10- ∅40 mm (#3 - #14)
Automatic loader with single bar count
Double wire up to ∅25 mm (#8)
Automatic bar alignment for high length accuracy
Automatic 180º clock/counterclockwise bending
Automatic bending pin change in few seconds
Ten different bending pins always available
Two 2D bending unit
New 3D bending unit
Automatic product unload and collection
A wide variety collecting device for stirrup and shapes are available
2D end 3D bending pins accordingly to national rules